Normal or Percent Scaled Parts can be Auto-Scaled better.
Lisias opened this issue ยท 1 comments
That's the issue:
Auto-Scale works fine when attaching (stack or radial) a Part with scalar scaled (currently only Meters) parts on other scalar scaled Part - ie, a fuel tank on another.
However, normalized or percentage scaled parts mimics the relative scale of the target part - what works well when you are attaching things on similar sized (and also scaled) parts. But became a bit cumbersome when the target is a big and unscaled part. See image below:
The Mk0 LF Tank was attached over am unscaled Kerbodyne S3-14400 Tank, and was scaled up appropriately. A R11 Baguette was radially attached to it, and since the Mk0 was scaled up 4 times, the Baguette followed suit into 400%.
But when attached to the S3-14400, since it's on the default size, so the Baguette gets attached on 100% too.
This schema works, but perhaps something more convenient can be achieved somehow?
Something to think about.