Only display DynMap layers if they are enabled in config

Question

Only display DynMap layers if they are enabled in config

Chromana opened this issue 13 years ago · 10 comments

Chromana commented 13 years ago

E.g. there is only the need for the Tomb layer in DynMap if I have them enabled in the config. Otherwise don't show them in DynMap.

dredhorse · Answer 1 · 2012-01-06T20:58:09.000Z

hmm... so you disabled them in the dynmap config but they still show up?

Chromana · Answer 2 · 2012-01-06T21:03:30.000Z

I'm not sure how I would disable them in DynMap config. I meant that if they are disabled in DTP that they shouldn't show up.

dredhorse · Answer 3 · 2012-01-07T13:39:40.000Z

that's what I meant... if you have the component disabled they shouldn't show up, and if you disable a certain layer it shouldn't show up either... need to check

dredhorse · Answer 4 · 2012-01-07T14:07:50.000Z

hm I can't reproduce it.. if I disable the dynmap intigration the layers are not there... if I disable a layer it is not their either..

Chromana · Answer 5 · 2012-01-07T19:05:58.000Z

Well here's a pastebin of my config http://pastebin.com/qcFWxJgk

dredhorse · Answer 6 · 2012-01-07T19:08:52.000Z

so it says you are using DnyMap Integration

Integrate into DynMap

integrateIntoDynmap: true

you should also have a DnyMapConfig.yml in that directory

dredhorse · Answer 7 · 2012-01-07T19:09:10.000Z

lol... I copy pasted it...

Chromana · Answer 8 · 2012-01-07T19:12:37.000Z

Oh well I feel dumb now. I didn't know that file existed!

dredhorse · Answer 9 · 2012-01-07T19:13:41.000Z

no probs... do I need to document it more?

Chromana · Answer 10 · 2012-01-07T19:16:02.000Z

Well in the comment above integrateIntoDynmap: true you could remind the user to configure DnyMapConfig.yml.

But it was all mostly because I'm an idiot :P

Share to

Integrate into DynMap