Hi, Neo here

This was an issue in a previous Blackvein build for quests, but the /quests quit command doesn't work. allow-quitting is set to true in the config, but when I type it ingame, it only gives me the usage for the command. I have turned on debug mode and nothing shows up when I type /quests quit. Below are screenshots of what happens in-game, and a snap of the console when I type it (to prove no error is occurring).

http://gyazo.com/0fcd56f8c8c994b5101ee1917c3519f3
http://gyazo.com/382baaa3f14f2d448a87a0c030e82e80 (After typing /quests quit it only shows this message)
http://gyazo.com/4f58b3b58b9de5fc00f89c714efc6e6f (Proof that there is no error)

Thanks in advance if you get to this. Also on a lesser note, you forgot to change seconds to milliseconds on the little prompt for 'redo delay' on the ingame editor:
http://gyazo.com/85abea677a34074dc7540df45be429b5

Thanks for your work, your revitalization of quests really helped us out :p

Regards,
Neo

The proper command is /quests quit questnamehere
So for the quest in question in your screenshot it would be /quests quit QUest Name
Unless your using an older version because I get the prompt

I'm using version 2.3.4, is there a newer version? And also I tried using /quests quit questnamehere and it did work, so thanks for that.

Yea, we have to make that distinction to all our players as well. "I tried, but it didn't let me" to which we say "It's /questS with an S on the end".

I don't know if it's an easy thing to do but maybe FlyingPikachu can tie in the Quit 'subcommand' to work on both /quest and /quests? shrug
-Form

I could, but then I'd be tying in every other sub-command for good measure. I wish Blackvein had made the 2 commands more distinctive, but that's not something I'm looking to change.

Thanks!