I remember, in AE1 I think, where the cables would flash white inside them when data was sent over them. I miss that! Can you please add it back please, it made wires cooler!

I Agree this should most defiantly be added back into it, Perhaps make the specific channel flash for that device?

Making a specific channel flash is not possible because the lines on the cable are not associated to a specific device. I think only glass cable and the corners from covered and smart cable should flash.

keep it configurable .. i also remember the immense lags ...

#20, but most likely no as it is a major performance issue.

Make it a config option, disabled by default?