Hi,

We are using the extracells ME Fluid Export Bus to pump water into the coolant port of a reactor. However we noticed during a restart of the server the reactor stops getting water.

So far the only solution we have found were to break the busses and replace them however thats become abit annoying. We arnt sure if its a problem with the extra cells fluid busses or the coolant port however we tried replacing it with thermal expansion fluiducts but id doesnt seem to pump enough water into our reactor. When it works the Extra cells busses can provide enough water for the reactor to make enough steam to run the turbine. Our turbine is 16x9 blocks

Do you have a recommended way of pumping water and steam out of your reactors?

Regards
Ajee

As far as i know, the recommened way for this version is tesseracts(They have no fluid limits ). Ender io also has something like this.
Maybe you could try multiple ports, or remote io interfaces.

I haven't tried(And i'not in the position to ), but for the water you could attach an ender io reservoir onto four ports.I don't think they have limits on the output, but i'm not sure.

Problems with buses reconnecting after restarts are likely issues with Extracells and should be reported to its author.

My generally-recommended solution, as stated above, is to use TE tesseracts for high-volume fluid transport.