Belt retains rotational force after placing tunnels, even if disconnected

Question

Belt retains rotational force after placing tunnels, even if disconnected

limbunny opened this issue 3 years ago · 6 comments

limbunny commented 3 years ago

Version: Create 3.1
Issue: Beltretains initial rotational force after placing down tunnels
Reproducable: yes
Setup: 12 block long belt EW direction, powered from SE. After placing three tunnels, the belt retains the current rpm, even if disconnected from the power source or additional machines are attached

github-actions · Answer 1 · 2021-12-18T12:10:18.000Z

This issue has been marked as stale because it has been inactive for 3 weeks. It will be closed if it remains inactive for another 3 weeks.

github-actions · Answer 2 · 2022-01-13T01:21:40.000Z

This issue has been closed since it has been inactive for 3 weeks since it was marked as stale.

Notenoughmail · Answer 3 · 2021-04-08T15:21:04.000Z

What happens if you break all the chain drives? They've been known to cause ghost power on occasion

limbunny · Answer 4 · 2021-04-09T19:03:03.000Z

I've removed all the chain drives and it still kept going

Elafir · Answer 5 · 2021-04-13T18:03:32.000Z

this glitch is also producible via using a vanilla piston to disconnect a shaft from it's power supply.

Noy0 · Answer 6 · 2021-04-13T17:40:41.000Z

and this can literally break things. I tried to adjust a speed controller in one of my builds, only to see the wheel fly off. Until I broke the belt with the tunnels attached, I couldn't adjust the speed.

Share to