Hi,

I'm building an underwater Base and want to drain it with the hose pulley. So I built some water wheels, a Pump, a Tank und the Hose Pulley in a straight line and let the hose down to the ground level of my underwater base room. I then realised that the shaft isn't block from the hose so the ocean is flowing into that base, surely being considered endless by create. So I built a small shaft around the hose to seal the base from the ocean. The Hose Pulley than drained the Waterblocks in the shaft until reaching the roof of the room it should drain and then nothing happens anymore. If I fill some water sourceblocks in the shaft they're drained as expected, but the room is not drained.
I've seen that there's a range-limit for the pump of 16 Blocks, not shure if this also counts to the Hose Pulley, would be kind of useless IMO. But the Pump is on Y 63 and the roof of my Base is at Y 53, the last drained Block is on Y 52 (which is the level of the roof blocks), so these are 11 Blocks, even if the hose counts into that range limit it shouldn't catch there.

I've also seperated the base into some smaller rooms using gravel but there's still just nothing drained.

If this still occurs on 0.5.1f open a new issue