Belts with brass casings never disconnect from power source
taedixon opened this issue ยท 3 comments
Create version: 0.2.4d
Minecraft version: 1.15.2
Steps to reproduce:
- Create a power source (I used a water wheel, but I assume it behaves the same with other ones)
- Attach a belt separated by a few shafts for spacing
- Add a brass case to some part of the belt
- disconnect the belt from the power source
- observe that the belt still moves
Attached is an image of a simple setup that also contains a stressometer and a rotational speed controller to demonstrate that increasing the stress of the disconnected system also increases the load on the power source
This issue has been marked as stale because it has been inactive for 3 weeks. It will be closed if it remains inactive for another 3 weeks.
This issue has been closed since it has been inactive for 3 weeks since it was marked as stale.
This also occurred when placing a shaft.
Both should be fixed in 2d04c87