Describe the Bug

cant even call it a bug, call it an very minor oversight
So this is just a glitch to be fixed on a rainy day

when printing stuff with the schematic cannon it is possible that the used schematics (then empty schematics) will stack in the output.
these can be taken out as a stack, and put into the schematic table as a stack
now when selecting a schematic from the dropdown of the table only one "filled" schematic will be in the output of the table

Reproduction Steps

See above or:

1. print several schematics using the cannon (minimal 2)
2. do NOT empty the cannons output slot so the empty schematics are able to form a stack
3. take this stack into your inventory
4. put these stacked schematic into the schematic stable
5. select a schematic to be applied from the dropdown

Expected Result

Unknown:
A: Should only be possible to put only a single empty schematic into the table
OR B: taking out a stack of schematics from the cannon should not be possible / or unstack doing this

guess B would be the most intuitive as you normally cant stack 'em at all

C: when a print is done and the output slot of the cannon is occupied the empty schematic just pops out onto the floor

Screenshots and Videos

No response

Crash Report or Log

No response

Operating System

windows 10

Mod Version

0.5.0g

Minecraft Version

1.19.2

Forge Version

43.2.3

Other Mods

No response

Additional Context

ignore the MC/create versions as this issue was - as far as i remember - already reproducible under 1.18 if not even 1.16.4

again very minor issue as in the end you only loose some light blue dye and paper