Machine controller requires looking at it with screwdriver to activate pump active status on a pipe
eragaxshim opened this issue ยท 0 comments
Checked for existing issues
- I have checked for existing issues, and have found none.
Tested latest version
- I have checked that this occurs on the latest version.
GregTech CEu Version
1.4.4
Minecraft Version
1.20.1
Recipe Viewer Installed
JEI
Environment
Single Player
Cross-Mod Interaction
No
Other Installed Mods
Gregtech Community Pack
Expected Behavior
When activating the machine controller with redstone, you expect it to immediately change the state of the pump that is installed on the same pipe.
Actual Behavior
The pump only starts (or stops) pumping when you look at it with the screwdriver, after you change the redstone state.
Steps to Reproduce
- Place two tanks, connect them with a pipe. Place a pump on the pipe, set it to import from the tank and put a machine controller on the same block.
- Fill up one of the tanks. The pump will start pumping fluid.
- Activate the machine controller with redstone, like a lever.
The pump will continue to pump. But when you open the controller with a screwdriver, it will stop. If you flick the switch, nothing will happen until you open the controller interface, after which it will start pumping again.
Additional Information
I don't have the time to investigate the cause but putting this here so I don't forget.