Minecraft Version

1.18

Immersive Engineering Version

1.18.2-8.2.2-154

Expected Behavior

Power is always on at the HV wire, so it should go through the transformers and turn on the lantern.

Actual Behavior

The lantern turns on as expected, but after wire cutting a wire and reconnecting, the lantern does not turn on.

Steps to reproduce

Here is a setup I have.

high voltage wire (always on) -> HV transformer -> MV relay -> transformer -> double LV connector block -> LV relay-> lantern

UPDATE: I removed the double LV connector block and used a simple LV relay, and the issue went away. So, I think the double LV block is causing this.

This all works out fine at first, and the lantern turns on. But if I use wire cutters on the double LV connector block and then reconnect the two wires as they were, power does not go from the double LV to the lantern. (It does go from the transformer to double LV connector block though.

I have a video here. Ignore the windmills, as they are not connected to anything:
https://drive.google.com/file/d/1VXJIqv4pPBj28xRmgLfldAhb_YK0MWf6/view?usp=sharing

This may also happen if you break one of the other wires between transformers. Also note that when I do this, sometimes the transformers also stop working, meaning only the HV wire works and I have to break and replace the transformers and connector block.

details================
single
player
forge: 1.18.2-forge-40.1.69

Debug Crash Log

NA

Bug appears to still be present in Immersive Engineering 1.19.2-9.1.2-159, on forge 43.2.0

Power flows fine on initial wire connection, but cutting the wires on an HV transformer using Engineer's Wire Cutters and re-connecting fails to restore power flow.

Video attached. Recreated consistently in Singleplayer using just Immersive Engineering and Forge.
https://youtu.be/z_i18ywe_8c