I'm trying to create Warded Runes, using a properly build tier 3 soul cage and the Warding Rune, however, all methods I've tried of creating the warded runes have failed:

• Placing around the soul cage
• Dropping on the soul cage
• Holding while on the soul cage
• Etc.

Using the warding rune to enchant the tear-soaked armor worked successfully, though.

This was reproduced on 1.16.5 with Lacrimis 2.0.2

Place a rune block directly on top of the warding rune and activate it. Keep in mind that the only way to move the block afterwards is to use the rune again.

That doesn't seem to work either.

(Then right clicked on the rest of the soul cage, and also went under and right clicked the middle, to check.)

Make sure you are supplying enough tears, but I will look into it

I have it connected to both a full crucible and the Block of Eternal Sadness, so I don't think that is the issue.

Though, what might be the issue are these lines here

They appear to reference the blocks position, which I would presume to be referring to the Warding Rune itself, therefore not checking the state of the block above.

Welp I fixed the issue in 1.17 but I forgot to do the same in 1.16. Give me a few minutes

New version is up on curseforge, sorry about that

It's no problem, thanks!