If you haven't already heard there was a community port of all of masa's mods, including litematica. Untill the full recode of masa's mods, I love to see compatibility with these versions.

They can be found here https://kosma.pl/masamods/

A working version:
git clone https://github.com/warmbroke/litematica-printer
go into the litematica-printer dir and make a directory named prebuilt, put litematica-fabric-1.19-0.11.3.jar and malilib-fabric-1.19-0.12.1.jar into the prebuilt dir, then run ./gradlew build.

for anyone who would like a prebuilt jar: litematica-printer-1.19-2.4.jar.zip

Thanks @warmbroke that worked wonderfully.

^

Can we maybe stop sending replies?

We have established that it worked and the

^

or other comments like that are unnecessarily spamming the opened issue.

Leaving a like on the comment is enough to know if it works or not thanks

very cool

Seems to work fine for me too, thanks!

Can we maybe stop sending replies?

We have established that it worked and the

^

or other comments like that are unnecessarily spamming the opened issue.

Leaving a like on the comment is enough to know if it works or not thanks

A working version: git clone https://github.com/warmbroke/litematica-printer go into the litematica-printer dir and make a directory named prebuilt, put litematica-fabric-1.19-0.11.3.jar and malilib-fabric-1.19-0.12.1.jar into the prebuilt dir, then run ./gradlew build.

for anyone who would like a prebuilt jar: litematica-printer-1.19-2.4.jar.zip

Good job, would you mind if I included your jar in my releases until masa gets 1.19 done and adds the versions to his maven repo? Don't feel like writing a dirty fix in the meantime, especially if you already beat me to it :)

A working version: git clone https://github.com/warmbroke/litematica-printer go into the litematica-printer dir and make a directory named prebuilt, put litematica-fabric-1.19-0.11.3.jar and malilib-fabric-1.19-0.12.1.jar into the prebuilt dir, then run ./gradlew build.
for anyone who would like a prebuilt jar: litematica-printer-1.19-2.4.jar.zip

Good job, would you mind if I included your jar in my releases until masa gets 1.19 done and adds the versions to his maven repo? Don't feel like writing a dirty fix in the meantime, especially if you already beat me to it :)

Totally fine with that.

I've noticed that the placement speed in the 1.19 version of printer is locked to above 2, while in the past it was possible to just input the value as low as you'd like, resulting in much faster printing. Is this done on purpose? And will the quicker printing get added again in the future?

Hey is there a version you know of for 1.19.1 ? or maybe this is already being built?

see #116
prebuilt jar litematica-printer-1.19.1-2.4.jar.zip