LittleTiles

LittleTiles

12M Downloads

Slice Connection Bug

Sybertox opened this issue ยท 6 comments

commented

Hello, I recently discovered a bug where sometimes existing slices arbitrary connect to new-made slices
and extend themselves if they both look in the same direction.
If the slices look in opposite directions the existing slices will turn the new ones into non-slice tiles. The hammer can sometimes select non-existing tiles near these full tiles which cannot be removed by it. It can only remove the non-existent tiles when the selection
has existent tiles.

This bug only happens when the already existent and new made slices are within the same block. It does not happen if they are on two different blocks.

Here are the forge and mod versions that I was using:

Forge: forge-1.12.2-14.23.5.2854-installer.jar
Creative Core: CreativeCore_v1.10.28_mc1.12.2.jar
LittleTiles: LittleTiles_v1.5.0-pre199_64_mc1.12.2.jar

I didn't use any other mod.

Here are two videos that show the bug:

https://streamable.com/hm81zc

https://streamable.com/5kplpq

commented

Fixed in the newest version. Thank you very much for reporting this issue. It was quite a serious one.

commented

I downloaded the newest versions of Creative Core (CreativeCore_v1.10.30_mc1.12.2.jar) and Little Tiles (LittleTiles_v1.5.0-pre199_67_mc1.12.2.jar).
Slices that are facing opposite directions still sometimes turn the new-made slices into non-slice tiles. https://streamable.com/pbffub

commented

But slices that look in the same direction don't extend the existing ones anymore.

commented

Fixed in the newest version :D

commented

Now I am getting a crash whenever I try to place slices facing opposite directions next to each other with the newest version of little tiles.
https://pastebin.com/vY9pMQxv

commented

Oh sorry, forgot to upload the new version of CreativeCore, should be available in a few minutes.