Pressure Chamber massive lagspike when completed.
Sakata-MC opened this issue · 2 comments
Minecraft Version
1.12.2
Forge Version
14.23.5.2844
Mod Version
pneumaticcraft-repressurized-1.12.2-0.11.5-371
Extra bits
ATM3:R base with a few things tossed in and/or yanked out.
MultiMC launcher
Expected Behavior
Place blocks normally, multiblock does its thing, continue on with life.
Current Behavior
I thought the client had crashed, however determined that the client was just under a massive lag spike. First time closed client. Tried again, and could not repeat. While getting to this page and getting ready to pull logs, it actually came back -- however a LOT of logging happened.
Possible Solution
Not 100% sure what is causing it. Chat seems to indicate an achievement was obtained, just after the client came back to life. Since it doesn't happen again, I think it may be related to achievements.
Steps to Reproduce
- Start getting into PneumaticCraft.
- Place edges and top/bottom of pressure chamber.
- Fill in walls with glass, w/ two valves.
- Place bottom interface (normally do this from inside the tank)
- Jump up top and place top interface
- wait for a bit -- it will seem as though client is dead -- it should recover.
MultiMC Log - with complaint about 10k lines:
https://gist.github.com/Sakata-MC/0b8688eef6caf4e5c60658813fe79e61
Actual logfile:
Is actually not able to upload cause its too flippin big, and gist times out.
