Not sure if this is just yet to be implemented, but on the home page it says that is has mekanism support. It does have some mekanism support, but isn't working as I would expect it to.

I have a 5x ore processing setup and occasionally, the crystalizers get clogged with left-over clean ore slurry that isn't enough to make a crystal.

I don't mind manually removing it on occasion, and I may have fixed the issue, however, I would like to monitor the crystalizers in case it happens again.

I tried some info readers to display progress to see when it stops, but it didn't work. I tried item readers to see when it stops producing crystals, but again no luck, and I tried fluid readers, but ofc clean ore slurry is a gas (for some reason) so that doesn't work. However, my system uses a lot of energy and as long as the crystalizers are working, they are using a little bit more energy than my cables carry per ticket, so the enrgy reader works.

I would like to replace the cables to make the system run smoothly, but figured that I should wait until I can monitor my machines another way.

Btw, it's not that the readers did not work, it's that they couldn't read what was in the crystalizers. The info readers just showed block info (like block faces and position) and the fluid and item readers just didn't see what was inside of the machines. I checked the info reader with a vanilla furnace and it worked fine, so I assume it is just mekanism compatibility, but I'm no programmer and could be wrong.

If anyone knows more about this mod and has successfully used this with mekanism, please let me know!
Thank you for your time. I love the mod and plan on using it a lot more.

Much of the integration which was available in older versions is not in newer versions, it will hopefully be implemented again as time goes on.

thank you for the prompt reply. I would really enjoy seeing more integrations in the future, but I assume you have quite the long to-do list already XD.
Thanks for the hard work you put in to this mod, it has definitely not gone to waste.

I assume the induction matrix is one of the items not yet supported? I tried to setup an energy display but it doesn't work, yet it does on EnderIO's capacitor bank (wanted to be sure I wasn't doing it wrong, I'm new to this mod).

Edit: It DOES work! If you attach the node to the Induction Port, and not just the multiblock, it can read the FE. Nice!