I play on a skyblock server that allows schematica but their anti-cheat won't allow printer to work. I've been reading the other suggestions on the forums about adjusting the schematica.jar file and the printer function but i'm not sure what program to use to edit the .jar file or what to actually edit. I was just wondering if someone could suggest a good editor and what lines of code I need to edit to place the blocks where my cross hair is and to slow the block placing down. Thanks for reading

I have added the check in order to allow server owners to disable the mod. It is possible to modify the source code to remove the check completely, but you'll have to figure that out on your own. Otherwise I might as well just remove the check.

Using the printer on the server works 50/50. Sometimes it works 100% but sometimes it places ghost blocks that I have to replace. I think it's just the speed of the block placing and the placing of blocks not looked at. Is there a few lines of code I could change for that or? And about the whole check thing, could I remove it myself from my end or is that just in the server side of things?

If you have access to the printer at all, then the check thing doesn't apply and you don't need to worry about it.

You can slow down the placement in the mod's setting page, I think (under Mod Options).

To me it sounds like their issue is placing stuff too fast and the regular anti-cheat not liking it? In which case, I think they want to go into the printer settings, but I'm not 100% sure if there is a setting to make sure you're looking at the right block before the printer places it (nor do I know how valuable that would be for a printer), only ones to change the speed of it