[1.12.2] GUI being buggy after a single tool modification
Cynosphere opened this issue ยท 6 comments
Bug Report
Observed Behaviour
Shows part dialog for a split second when clicking on a part and cannot be interacted with afterwards until re-opening the GUI which it then will just happen again trying to click on a part.
Expected Behaviour
Being able to interact with the part dialog normally and it staying
Minimal setup needed to reproduce
- Forge version: 1.12.2- 14.23.5.2847
- Tetra version: 0.39.1
- Tetra configuration: Unmodified from default
- Other mods: https://gist.github.com/Cynosphere/2c87d8b4034e95e8418369290c2a0769
Steps to reproduce
- Obtain a vanilla tool
- Put it in the table
- Modify a part
- Attempt to modify another part (same or different)
I'm unable to reproduce this in a setup with only tetra. Is that the minimal mod setup required for this issue occur?
That's alot of stuff to set up properly by hand :s. You're not running a modpack by any chance?
I am, but I don't know how legally I can distribute it as its just a MultiMC export since I don't really use Twitch's client to make/play packs.
Nevermind. The gif wasn't playing right before. I think my issue is related, but separate. I'll open a new issue.