Bug Report

Observed Behaviour
The forged vents block model does not properly orientate themselves to their hitboxes in north/south directions.

This occurs with forged vents placed in creative and generated in the world.

Expected Behaviour
The rendered block to properly face correct direction, in this case it should render the block texture following the block's hitbox like it does when facing east/west.

Minimal setup needed to reproduce

• Forge version: 35.1.37
• Tetra version: 1.16.4-3.6.0
• Tetra configuration: Default configuration used.
• Other mods:

Steps to reproduce
Try to place forged vent block so it would be facing north/south.

Ah, this was fixed a while back!

I can confirm this also occurs in versions 3.5.3 and 3.6.1 as well.

I can't reproduce this. Can you press f3 and take a screenshot while looking at one of the vents?

Got them. I have both orientations placed with F3 data included.
First orientation (working)

Second orientation (broken - using same model of above, yet hitbox says otherwise)

Cheers! Did you place those by hand?

Yes, both of those in the screenshots are placed by hand. The second screenshot showing the one on the right also occurs in structures that try to spawn the forged vents in that orientation. I can try and find ones where they spawn naturally if needed.

Just in case it is needed, I have found one in the underground structures. This one was spawned naturally in the world. f3 data is included in the screenshot.

I have this same issue; but I have already broken the vents.