Terminal + connector + multiple chests -> everything works great

Terminal + connector + cables -> doesn't work at all. Tried all of the configurations known to men. Including those in the curseforge video.

you probably figured it out

terminal goes on inventory cable connector
then on cable into
inventory connector , the block one , there needs to be one for every network

or terminal can be directly on the inventory connector , block version ,
cables then have to be connected to the inventory connector to other inventory cable connectors onto a chest

settings state there is a limit of 2048 for a network I think

Same issue, I've tried everything, cannot get cables to work. I have terminal connected to inventory connector, then inventory cable connector from the inventory connector, into cable line, into inventory cable connector on the other end either into a chest, an inventory trim -> chest, or an inventory connector -> chest, nothing works.

The configuration that worked for me was terminal -> inventory cable connector -> inventory cable(s) -> inventory cable connector -> inventory connector block -> (trim, chests, etc.). Basically, every separate set of inventories (my chests are grouped in areas) is connected (sometimes directly, sometimes via trim) to a single inventory connector block and inventory connector cable. All of those connections meet each other via the cables.

Some of the posts above suggest I shouldn't need the cable connector AND the block connector together, but that was what I found worked.

Oh, and make sure your connector cable is facing the right way (flat side to terminal/connector block).

@tokuninai I made a little guide (still a WIP) that may help you understand how to properly set up a system
Tom’s Simple Storage Basic Guide

The configuration that worked for me was terminal -> inventory cable connector -> inventory cable(s) -> inventory cable connector -> inventory connector block -> (trim, chests, etc.). Basically, every separate set of inventories (my chests are grouped in areas) is connected (sometimes directly, sometimes via trim) to a single inventory connector block and inventory connector cable. All of those connections meet each other via the cables.

Some of the posts above suggest I shouldn't need the cable connector AND the block connector together, but that was what I found worked.

Oh, and make sure your connector cable is facing the right way (flat side to terminal/connector block).

would you be able to take a screenshot? i still can't get it working