I'm using a translator.

Small HSS-S Gear should be made as above in LEM multi-block, but HSS-S Plate is being made

I didn't take a picture, but when I give programming of 1 and 10 to the 2 input buses in the LMP multi-block,

Recognizing the last set of 10, the result is only a recipe for programming 10.

I think it's probably the same error.

Is the "Distinct Buses" of each Input Bus set to Yes?

각 입력 버스의 "고유 버스"가 예로 설정되어 있습니까?

I've seen this comment and tried it, but it still doesn't work. Is there a set maximum number of Input Buses for one multiblock?

Wait, you seem to be using the wrong mold.
"Casting Mold" is the Mold for Fluid Solidifier, Extruder needs "Extruder Mold".

I've seen this comment and tried it, but it still doesn't work. Is there a set maximum number of Input Buses for one multiblock?

As indicated in JEI's Multiblock Info, there is an upper limit to the total number of buses and hatches, because a minimum number of casings for each.
However, that upper limit is high and is not an immediate obstacle.
In fact, my LEM has 11 input busses, and I have no problem with their operation, and each one creates the correct item.

Wait, you seem to be using the wrong mold. "Casting Mold" is the Mold for Fluid Solidifier, Extruder needs "Extruder Mold".

I've seen this comment and tried it, but it still doesn't work. Is there a set maximum number of Input Buses for one multiblock?

As indicated in JEI's Multiblock Info, there is an upper limit to the total number of buses and hatches, because a minimum number of casings for each. However, that upper limit is high and is not an immediate obstacle. In fact, my LEM has 11 input busses, and I have no problem with their operation, and each one creates the correct item.

I'm sorry. Small Tungstensteel Gear and Small Stainless Steel Geer have been produced before, so I didn't notice it at all.