Divine Journey 2

Divine Journey 2

Modpacks
636k Downloads

Atum + EnderIO Item Conduit Dupe

BiFrossGames opened this issue · 3 comments

commented

Modpack version:
2.5.0

Description:
When pulling items out from a locked Sarcophagus using an Item Conduit, the first available item in the sarcophagus is duped into the receiving chest.

Steps to reproduce:

  1. Find a pyramid, and get to the locked sarcophagus
  2. Place a chest down one block away from the Sarcophagus
  3. Place an Item Conduit between the Sarcophagus and receiving inventory.

Your setup should look like this.
image

  1. Modify the Conduit's faces to pull items from the Sarcophagus and into the receiving inventory.

Sarcophagus UI
image
Inventory UI
image

  1. Observe that in the glimpses of clicking the locked sarcophagus, the first item in the Sarcophagus' inventory is being duped.

Depending on your luck, it will be dupes of one artifact, or just sand, whatever is part of the Sarcophagus loot table.

In our case it was Dirty Rings.
image

Expected behavior:
I expected the Sarcophagus to empty out all of it's items, or straight up not allow anything to be pulled out. I'm willing to bet this works with hoppers, too.

commented

I´ve provided a link to a build, with an attempted fix on the Atum issue. If someone could try that out, that would be much appreciated :)

Also if you could try with vanilla hoppers to see if it happens there too.

commented

Tested item extracting from a Locked Sarcophagus and inserting into with the following:

  • EnderIO's Item Conduits: can extract items. Cannot insert items.
  • EnderIO's Data Conduits: do not connect to the inventory.
  • Mekanism's Logistical Transporters: do not connect to the inventory.
  • Hoppers: do not extract items. Can insert items.
  • Applied Energistics 2 Storage Bus: can see the items, but cannot extract them (even on "only report accessible items"). Cannot insert items
  • Applied Energistics 2 Import/Export Bus: neither do anything.

@GirafiStudios unfortunately, the file (the one linked here: TeamMetallurgy/Atum2#352 (comment)) you linked to is for 1.16.5, while we are working on 1.12.2.

commented

This is very peculiar. Not sure if the bug is on Atum's side or EnderIO's side. Can you test with more types of Conduits/Ducts/Pipes/etc.? Because if they also work, then the bug is on Atum's side.

Though I just checked and it's been reported there less than a day ago: TeamMetallurgy/Atum2#352 Hopefully we can get it fixed!