Description:

I noticed this morning that some machines powered by a Flat Flux Accessor stopped receiving energy. Removing and replacing the Flat Flux Accessor temporarily resolved the issue.

After inspecting all my machines, I found that only those powered by a Flat Flux Accessor were affected. Machines connected via interfaces/pattern providers with an Induction Card do not seem to experience this issue.

All the machines and their corresponding Flat Flux Accessors are located in chunk-loaded areas, so chunk loading does not appear to be the cause.

• Machines using Flat Flux Accessor setups are the only ones affected.
• Replacing the Flat Flux Accessor temporarily resolves the issue.
• The problem persists despite chunk loading.
• interfaces/pattern providers with an Induction Card work without issues.

Steps to Reproduce:

1. Set up machines connected to a Flat Flux Accessor.
2. Ensure the area is chunk-loaded.
3. Wait for some time or perform routine operations.
4. Observe that machines powered by the Flat Flux Accessor stop receiving energy.
5. Remove and replace the Flat Flux Accessor to temporarily fix the issue.

Expected Behavior:

Machines powered by a Flat Flux Accessor should consistently receive energy without interruption.

Observed Behavior:

Machines stop receiving energy intermittently when connected via a Flat Flux Accessor. interfaces/pattern providers with an Induction Card are not affected.

Environment:

Mod Version: 1.21-2.0.3

fixed