Logistics pipe network does not cross the machine interface

Question

Logistics pipe network does not cross the machine interface

ltouroumov opened this issue 10 years ago · 2 comments

ltouroumov commented 10 years ago

Putting either a basic logistics pipe or a standard pipe in the interface in auto mode does not allow the logistics network to cross the interface.

davenonymous · Answer 1 · 2015-03-22T11:29:09.000Z

Not going to support logistics pipes, sorry.

XFactHD · Answer 2 · 2015-04-10T00:29:48.000Z

If you have AE2 installed, you can put a ME cable in the CM interface and put an ME interface on the outside and on the inside of the CM and then some logistics pipes on the ME interfaces. Which pipes you need to use is written on the AE2 wiki.

Share to